How to properly clean a Shower

176

Introduction

How to clean a shower properly has been a common question in recent times. That is a task that appears more stringent than it is. If you possess the needed tools, technique, and products, and perform this activity at regular intervals, you will discover that your shower will be in a good state.

Shower cleaning brush

What you need for Shower cleaning

Tile and Tub cleaner: For Glass walls, porcelain, ceramic tile, or glass tile, you can utilize any tile and tub cleaner you so desire. Locally made soap scum cleaner can be used. Natural surfaces like slate, granite, or travertine, can only be clean using a specialty stone cleaner or a neutral soap.

Double-sided sponge: Go for the non-scratching type, to prevent scuffing any finishes. Don’t utilize cheap sponge here; using a cheap sponge will increase your work-time.

Microfiber cloths: Used for drying tub and walls. Also, you can use a squeegee if you possess one.

Baking soda: For some extra abrasion.

Full-Strength vinegar: For glass shower doors that are heavily-stained.

 

Shower Cleaning steps

Step1

Take out everything from inside the shower: sponges, soap bars, and bottles.

Step 2

Take all curtains out of the way; remove them totally or flip them over the shower bar. Generously spray the walls with your tile and tub cleaner and allow to sit for about 5 minutes. Allowing the cleaner to sit will enable the product to carry out the task for your behalf. So, the more time you allow the cleaner to sit, the easier it is to break down soap scum. Ensure you do not spray the floor or tub of the shower. Spraying of the tub or floor of the shower will be left until the end to ease the cleaning process.

Step 3

With the scrubby part of your shower cleaning brush, begin scrubbing at the extreme left wall of the shower, and keep scrubbing downwards until you arrive at the bottom of the wall. After that, move on to the next wall. For soap scum that is heavy, sprinkle some amount of baking soda onto your brush and apply little water on it. The abrasion will assist in removing the scum. Start from left to right, top to bottom. Avoid scrubbing in circles, as this is a time consumer. Continue doing this until all parts of the walls have been cleaned thoroughly. It is important not to rinse yet.

Step 4

Carry out steps 2 and 3 again for the tub. Apply spray, leave to sit for about 5-10 minutes, and then you can scrub, beginning at on end to the other end. It is important to note that if you own an acrylic tub, then you have to utilize the soft part of the sponge.

Step 5

Allow the shower to run on hot water. If you have a shower head that is removable, begin spraying the walls of the shower, applying the same pattern you used for cleaning. If you don’t, allow the faucet to run and utilize a jug or container to rinse the walls. After rinsing, use a squeegee to expel all the water remaining on the walls, then immediately follow that up by wiping with a clean cloth. Carry out the same activity for the tub.

Conclusion

To confirm if all soap scum is gone, closely observe your tiles and tub on a certain angle. You should not discover any dull spots or greyish lines. You can also use your hands to feel it: If any resistance is experienced while running your hands on the surface, it indicates that there is still residue. Finally, all tools needed for shower cleaning are available for purchase at Banggood.

Leave a Reply

avatar